Polished Cut Tuff

create:polished_cut_tuff

Schematics that use this block:

TrainFactory + Trainstation #30daycreatemodchallenge

This is a 35x35 Tainfactory that can produce train tracks and sturdy sheets. the train-tracks are completely automated but the sturdy sheets aren't, u need to put magma blocks in a chest made fir them because its not possible to automate magma blocks with create BUT if you downloaded an addon for that u can still hook up your 2 farms thanks to the train track going thru the factory. Those traintracks going thru can be used for a lot of thingy like just using it as a station or use it to deposit materials and take materials at the farm with automated trains (highly recommend that). I also tryed to make the inside look good. so enjoy :D

Factory [WIP]

this is a work in progress factory that you can use and expand in your own way. you will need the create mod, obviously, and it is optional, but you can get the enchantment mod for the create mod as well. it features a big steam engine in the centre of the factory and has an elevator, stress unit display board, auto crafters, hyper enchant spot [they don't have enchants on them because you should pick them] and a little fun launch cycle around the factory. it does not use creative motors or creative fluid tanks. [side note: ignore the slimes, plus you will need to add your own hyper experience generator for the hyper enchant setup, because there isnt one provided in this schematic]

Create: 30 Day building challenge - Iron Factory

This is my Create iron farm made for Uberswee's 30 Day building challenge. This Factory is not created with efficiency in mind, it is overly complicated, expensive and slow. The objective i had in mind was to make a good looking building with create contraptions and a very visually appealing iron factory, all the steps cobble follows to turn into iron ingots are displayed with glass. **Disclaimer: To start the drilling contraption make sure to follow the sign i left in the schematic. If for some reason the signs are not there or got deleted here are the instructions: 1. Put a mechanical bearing on top of the creative motor at the bottom of the drill. 2. Waterlog the two slabs that are at the sides of the creative motor 3. Put lava on top of the water all around the well. 4. Put a creative motor/rotational power in a hole in front of the drill (it is marked with a sign) to start the drilling. 5. Enjoy 😀