Cut Dripstone

create:cut_dripstone

Schematics that use this block:

Steam Engine Room (Non-Competition)

Starting off with the first day is of course a steam engine room, how else will we make power for all our factories? Maybe unlike other people doing this challenge, I will be focusing not aesthetics, but instead power (so quantity>quality) although the steam engine room is decorated. (there isn't much to a good steam engine room, so I decorated it this time to make it look a tad bit better) *Note 2: Building output is in the back* How to setup: #1 right click the windmill bearings to turn them on. Notice that when turning both of them on, the stress caps at 100% (perfectly stressed) [the wind turbines are in there own sealed off room] #2 Add water into the infinite water source holes (also inside it's own dedicated sealed off room) #3 add lava above the dripstone cauldrons #4 add buckets onto the top depots of the lava bucket filling setups If you are using this for the competition, use the 25x25_actual schematic (different post) Please use the other post of this if you ARE using this for the competition

Airship by Migz

This was an Airship from one of my sponsored videos. I hired a builder called Migz on Fiverr to build this using only the base Create mod.

Steam Engine Room #30 Day Challenge (25x25x25)

Starting off with the first day is of course a steam engine room, how else will we make power for all our factories? Maybe unlike other people doing this challenge, I will be focusing not aesthetics, but instead power (so quantity>quality) although the steam engine room is decorated. (there isn't much to a good steam engine room, so I decorated it this time to make it look a tad bit better)*Note: the roof did get cut off to fit in the 25x25 margins* *Note 2: Building output is in the back* How to setup: #1 right click the windmill bearings to turn them on. Notice that when turning both of them on, the stress caps at 100% (perfectly stressed) [the wind turbines are in there own sealed off room] #2 Add water into the infinite water source holes (also inside it's own dedicated sealed off room) #3 add lava above the dripstone cauldrons #4 add buckets onto the top depots of the lava bucket filling setups If you are using this for the competition, use the 25x25_actual schematic Please use the other post of this if you are not using this for the competition